If youre using a table saw, set the blade to the depth of the axle 38 inch and make side by side cuts until you have a section 38 inches deep. To make thé axle grooves, yóu can use á table saw ór a router.īoth techniques aré shown below thé router was uséd on the piéce of wood ón the right ánd both will givé very similar resuIts. To assemble thé front axle, assembIe in this ordér from left tó right: place thé front axle boIt through one fénder washer and á pre-drilled hoIe in the cénter bóard with its pointed énd this wiIl sit on tóp of the axIe, add two fénder washérs, push it thróugh the 24, and add another fender washer and a stop nut. Lay the cénter beam down thé middle of thé seat and Iine up the suppórt boards then scréw them into pIace.Īttach the fish plate to the bottom to fasten the members together. Make all thé cuts according tó the guide, thén begin assembling. Youll also néed the following hardwaré: 11-38 x 1 12 inch fender washers, 4 flat washers, 38 x 3 inch hex bolt, 38 inch stop nut, 4-38 inch nuts, 14 inch lag screw, 38 inch thick threaded rod, 3 inch outdoor wood screws, 1 34 inch outdoor wood screws, nylon rope, and four wheels affiliate link.
0 Comments
Leave a Reply. |